send link to app

Translink Gateway 3


4.2 ( 8832 ratings )
Economia Stili e tendenze
Sviluppatore Rohan Hamer
Libero

The Translink C-Bus gateway v3 provides 2 way communication and control of Clipsals C-Bus lighting and automation systems using Apples iPhone or iPad.

Consisting of a combination of hardware controller (purchased Separately) and software app, the Translink allows users the freedom of monitoring and control from anywhere inside their wireless network, or anywhere in the world via the internet.

Easy to install and easy to configure, with the ability for end users to setup and change pages however and whenever they like.

The Translink group of products provide a gateway into a Clipsal C-Bus network, and present the user with an easy to use interface with real time viewing and control of their network.
Designed for home and commercial use, the Translink can be used where ever wireless control is needed.

The Translink App is a native Apple iOS application which runs on both the iPad and iPhoneand can be used as a low cost remote control for conference rooms or presentation areas).

In Addition the iOS app allows for user customisation of pages, enabling the end user to setup or change the pages as they like without the need for a service call by the installer.

Multiple Translink Controllers for different systems, floors or even properties can be accessed from a single iOS device by simply selecting from a menu. Each Translink controller has its own set of configuration pages.

New In Version 3:
+ Includes support for C-Bus enabled Alarm panels such as HomeSafe, Ness D8/16 and Ness M1.
+ Soft keypad for arming and disarming alarm.
+ Support for C-Bus Matrix audio selection with dedicated widgets.
+ Support for HVAC Temperature application broadcast messages from newer C-Bus Thermostats
+ Active Icons that change appearance with group address state (where applicable).
+ Over 40 new icons, plus many redrawn for active state display.
+ 64 bit support.
+ iOS 9 + support.

NOTES:

* This app requires the purchase of a Translink Controller V3 or a firmware upgrade to existing V2.x Translink Controllers.

http://www.hamfield.com.au